The equipment consists of a body, a loading dock with a compression mechanism and an exhaust device inside the body. The hydraulic installation and control mechanism, all functions and load distribution are conveniently mounted, in accordance with the technical specification of the truck chassis on which they are mounted. All equipment is manufactured in series production taking into account the regulations in force
Net body volume: 16 — 24 mc;
Loading bin volumeIngredients: 1.5 μl - 2.5 μl
Compression cycle: 25 sec;
Unloading time: 35 — 45 sec;
The degree of compaction: 1:6;
Compression mode: by translation;
To the collector compartment there are continuous welds, in order to avoid the formation of rust. The shape of the collector compartment is such as to provide high rigidity, with smooth walls on the outside horizontally reinforced U-profiles at the top and bottom Mud guards over the front and rear wheels.
Moves inside the body on the profiled itself from the floor to the top;
The exhaust device is easy to replace being made of polyamide clogs assembled by rivets;
The exhaust device is mainly driven by a double-acting telescopic cylinder. It is located at the rear of the body when it is empty, and moves automatically to the front by means of the pressure valve when waste is loaded into the drain;
The leg is mounted on the body through upper hinges and opens with the help of a double-acting hydraulic cylinder. It turns automatically when it is closed. The upper hinges, locking hooks and hydraulic cylinders are mounted on the same axle in order to prevent overload of the rear structure. A profiled sealing gasket is installed here, in order to prevent leakage of dirty water from the body. The gasket is made of a rubber that is resistant to wear and acids. The press plate is thus sized to empty the tub in a single pass. The slides are made of steel bars 50 mm thick and the slide is provided with 4 high density nylon clogs. Sabots are very easy to replace from the outside because the self has no stop. The slide also has 4 central studs to keep it securely in the center position. There are also anti-cading safety valves mounted on the hydraulic cylinders to prevent the drain from falling off in the event of a broken hose. There is a tap for draining dirty water under the drain. Inside the collector cover there are no lubrication points, electrical or hydraulic components, to avoid difficult or dangerous maintenance operations.
24 V electrical system
Electrical connections with plugs for easy maintenance and repair
Sound indication for walking back Sealance IP65
Safety buttons on both sides of the superstructure.
Hydraulic Plant
The pump is mounted on the power outlet of the truck gearbox, and the capacity is chosen so that in 25 - 30 seconds a compression cycle is achieved. The power outlet is operated from the cabin. All pipes are made by cold rolling and protected by phosphating in accordance with DIN 2391C. All connections are EO type and all pressure hoses comply with SAE 100 R2 standards. Suction hoses comply with SAE 100R4 standards. All hydraulic cylinders are made of honed pipes in accordance with DIN 2391C and with a high degree of chrome plating.
2 double acting hydraulic cylinders for lifting and turning: 80, 120, 240 Eurotubes,
360 L and eurocontainers of 600 — 1100 L;
Emptying cycle for 1.100-litre containers: 25 sec.
Low loading possibility for manual loading of bulk or bulky garbage.
Side protectors
Lifting capacity: approx. 750 kg.
Loader for garbage containers of 120 — 1,100 liters. Safety bar between body and leg used during repairs. Lamp at the back for night work. Two foldable stairs mounted at the rear with operator support bars and presence sensors Video camera at the rear with monitor in the cabin for monitoring the work area Girofar yellow, fog lights, turn signal lamp, rear fog lamp. Dirty water tank in front of the body.
Automatic greasing plant
Lift for containers 4 — 10 mc
